E-Bike Controller Baserunner with L1019 motor plug
The Baserunner L10 is a compact field-oriented motor controller and enclosure that fits inside the Hailong and Reention downtube battery cradles. It is compatible with up to 14S (20-max. 60V) battery packs and is terminated with a L1019 waterproof HiGo motor plug. It supports up to 80A peak phase current (45-50A cont.). Requires PC setup to mate and configure with a given motor, and this requires this programming cable. If your battery doesn´t have an on/off switch you should expect to wire in a separate switch. Below you can download the user manual.
|Dimensions (LxWxH, mm)||90 x 55 x 15|
|Actual Weight||0,20 kg|
|Max. Battery Amps||40A|
|Low Voltage Cutoff||Programmable|
New V4 Model uses only waterproof signal plugs:
8-pin HiGo plug for connecting Cycle Analyst V3 (CA3-WP)
9-pin Cusmade Mains signal plug for harnesses to 3rd party displays, alternately use to power rear light
6-pin HiGo MiniB for direct PAS or Torque Sensor when using 3rd party displays
The Baserunner L10 purchased on its own has bare + and - lead wires that will need to be soldered to the pins of the connector present in your original base plate (battery plate).
Made by Grin (Canada). More product information can be found here.
Nutze diesen Controller zusammen mit dem CA3 an meinem Ebike. 50A bzw. 90A peak sind super, vor allem klein ist das Teil. Sehr zu empfehlen.