10 ml Statorade ferrofluid, magnetic cooling liquid

Cooling for Hub Motors

The original Statorade by ebikes.ca is used. You have to seal the motor afterwards. Togheter with a syringe

The ferrofluid provides a better transfer of heat to the engine housing and the heat can be transported away better. You can find more information here

This offer isn't for the 100 ml bottle in the pictures, but for 10 ml.

How to

Remove screws from side cover

Mark the position, the side covers are factory-aligned

Release circlip

Use a old brake disc and lift the cover with a puller. Alternatively, 2 tire levers can be used, thread them laterally on the lid

The side covers should be sealed with a heat-resistant sealant to keep the fluid in at higher revs

Reassemble at the marking and tight it 5-6 Nm, opposite screws evenly from all sides. Reinstall circlip.

mark, lift the drive side with an old sprocket

Fill the Statorade, the magnets pull the liquid to the right place. Join cover to marking, attach sealant and screw back. Finished