This reduction gear is made of steel and can be used as replacement for the original nylon gear of Bafang BBSHD motors. Perfect for those, who use Bafang BBSHD with more powerful controllers (more than 30A).
- Noisier than original nylon gear
- Reduced in size to minimize noise
- Pre-lubed with grade
This gear has been designed to be as quit as possible. The gear size was reduced, so it has minimal contact and further less noise. This steel gear is noticeably louder than the stock nylon gear but it gets quiter with use as it breaks in.Dimensions:
- Outer diameter: 53 mm
- Inner diameter: 15,7 mm
- Width (teeth): 20,1 mm
- Width (bearing): 26,0 mm
Only fits for Bafang BBSHD. Manufactured by LUNA.
How to replace nylon gear:
unmount the controller
remove the silicone
and all the rubber sealings
open the screws of the stator side and remove it
open up the 3 screws with force and pressure, use the right bit and a power drill
insert 3x M5 screws to lift up the plate
replace the nylon gear and grease it well. Replace also the gaskets, if they are damaged
Clean the old silicone, insert the rubber seals or replace them.