Information: This price is only for the engine without accessories (chainring, display, throttle, ...). If you need a complete set, we recommend using our configurator.
Upgrade your bike with the most powerful mid drive electric bike kit from Bafang! Equipped with a 12fet controller with 30A and the possibility to use 14S 58,8V batteries, the motor provides 1.6 kW peak!With this powerful and quiet motor with 160 Nm you can climb everywhere. A easy installation and the power transmission on all bike gears also allow long mountain climbs without overheating. The Bafang BBSHD Impulsis is significantly more robust than its little brother BBS02 with 30A constant power available. It has a internal gear ratio of 21.9:1, which allows higher RPMs for a better efficiency.
This motor fits to bottom brackets from 68 to 120 mm:
68 mm = 68 to 75 mm
90 mm = 75 to 92 mm (e.g. Pressfit BB92)
100 mm = 90 to 100 mm
120 mm = 100 to 120 mm
The axle size is measured without the thread. eventually you need some washers, to have a flat triangle plate.
- Fixing parts
- all the necessary cables and connectors, including a Anderson 45 wire to your battery
- speed sensor
- optional with extra connector for Gearsensor and 6V light cable with approx. 500 mA. The DPC18 display (not included) has its own light switch, which supplies power to the connector and turns a connected light on. The controller has an additional connection for the Gearsensor, so that both brake connections on the handlebar can be used. If these plugs are not used, they should be sealed, that no water can cause electronic damage. The Gearsensor isn't included.
You need a special tool for the axle, the second ring can be tighten with the bottom bracket bearing tool for Shimano, SRAM, … For the rest Allen tools are required.
We recommend the use of sensors - for example gearsensor or brake sensor.
If you want to reprogram the controller settings please use the USB programming cable.
INSTALLATION GUIDE from Luna Cycles
You can use 48V 13S and 52V 14S batteries, it doesn't work for 36V. You can set also a low voltage cutoff in the programming (40-43V).