Cable set for Phaserunner motor controller

These cable sets are suitable for use with the Phaserunner motor controller.

Various cable sets – simply select above:

1) Battery cable only

• approx. 80 cm High Flex battery cable XT60 to Anderson 45 (2x 13 AWG + 2x 18 AWG each)

2) BBSHD:

• approx. 80 cm High Flex battery cable XT60 to Anderson 45 (13+18 AWG)
• approx. 70 cm phase cable (MT60), reverb cable (JST), compatible with BBSHD
• approx. 150 cm from Phaserunner to Cycle Analyst V3 (8-pin connector, with JST on request)

Temperature sensor and PAS are taken over by the BBSHD and can only be used in combination with the Cycle Analyst V3.

3) Standard:

• approx. 80 cm High Flex battery cable XT60 to Anderson 45 (2x 13 AWG + 2x 18 AWG each)
• approx. 115 cm phase/reverb cable from MT60 to Anderson 45 (12 AWG) and 2x JST for reverb

4) HiGo Z910

• approx. 80 cm High Flex battery cable XT60 to Anderson 45 (13+18 AWG)
• approx. 97 cm phase/reverb cable from MT60 and JST to 9pin HiGo Z910 socket (motor side)

To the Phaserunner controller (currently not available):

• Dimensions (L x W x H): 99 x 40 x 34 mm
• Weight: 0.26 kg
• Max battery amperes: 50 A
• Battery range: 30V to 90V (21S Li-Ion, 24s LiFe)
• Low-voltage switch-off: programmable
• MOSFETs 6X 100V, 3mOhm
• Made in Canada by Grin

Requires PC configuration to configure the motor, the USB>TTL communication cable is required (same for CA, Satiator)

The controller is ideally suited for the operation of brushless motors for electric vehicles in the power range of 500-2000 watts, with smooth response of an FOC with a torque controller. This controller was developed as a universal device that fits on almost any bicycle frame and can handle almost any motor system. Is compatible with a 24V – 72V battery, with a peak phase current of over 90 amps. Continuous current capability without additional heat sink is typically 45-50 amps. Includes throttle input, cycle analyst and programming plug. Optional cable to motor and battery.

Properties

• Remote on/off switch
• Direct connector for V2 and V3 Cycle Analyst
• Proportional regeneration available through gas inlet or separately
• Works with or without Hall sensors and even with very high eRPMs (60,000 eRPM +)
• Waterproof, 100% encapsulated electronics
• Fully programmable parameters (rain voltage, maximum phase and battery currents, etc.)
• Field Weakening enables motors to be operated faster than the normal back EMF limit
• Higher motor efficiency at low speeds / high torques
• Torque-based throttle lever command (no twitching throttle lever with powerful system)
• Automatic temperature control to prevent the controller from overheating

Further information and software on the GRIN website

and at Endless Sphere