Configure your e-bike retrofit kit with the CYC Photon motor

In this configurator, you can put together your retrofit kit with the CYC PHOTON mid-motor. Regardless of whether you prefer the 250W or 750W version of the motor – it is the same motor and only differs in the firmware. Just write to us if you want us to install the 250W version.

The motor available for selection is compatible with different pressfit and BSA bottom brackets. You should check this point on your bike beforehand – you will need this when selecting the motor. You can see how this works here.

Measuring the bottom bracket width on the bike - here's how >>

The best way to do this is to turn the bike over. Only the frame width is measured – make sure that no bearing shells are measured against the frame. If you are not sure, you are welcome to send us a photo. It is even easier to determine the width after removing the bottom bracket.

You can save your configuration using the SAVE button. If you are logged into your customer account, you can edit your configurations at any time.

Photon configurator

Required
Motor
Display
Kettenblatt
Kurbelarme
Akku
Ladegerät
Werkzeuge / Tools

Erforderliche Komponenten

Motor
— Choose —
— Collapse —
Display
— Choose —
— Collapse —
Kettenblatt
— Choose —
— Collapse —
Kurbelarme
— Choose —
— Collapse —
Akku
— Choose —
— Collapse —
Ladegerät
— Choose —
— Collapse —

Empfohlene Produkte

Werkzeuge / Tools
— Choose —
— Collapse —
Kabelsammlung
— Choose —
— Collapse —

Optionale Artikel

Gashebel
— Choose —
— Collapse —
Bremssensoren
— Choose —
— Collapse —

Fahrradzubehör

Zubehör
— Choose —
— Collapse —

For the use of this drive unit on public roads and paths, the applicable regulations of your country must be observed and the settings on the motor with regard to maximum power and speed must be made accordingly. The user is responsible for complying with these regulations. Otherwise, this product may only be used on private and secured terrain!