Configure your personal e-bike conversion kit with 250W Bafang BBS01 mid drive motor!
This motor is suitable for bottom bracket widths from 68 to 75 mm. If the bottom bracket size of your bike is wider, then we recommend using our axle extension (can be selected in the configurator). How to measure your bottom bracket size can be found in the following step (more information).
More Information
Measure Bottom Bracket Size:
- Turn your bike upside down
- Measure width of frame in mm - without bearings
Frame width at bottom bracket - 68 mm
Frame width at bottom bracket - 90 mm (bearings removed in picture obove)
This engines is light weight and compact. The "little brother" of the 1000W BBSHD engine is perfect for those who don´t need so much power and enjoy the lower weight (set without battery ca. 5-6 kg). The easy installation allows a quick conversion to an e-bike. The motor uses all your gears and thus operates at an efficient speed.This allows long mountain trails without overheating.
The motor axle has a diameter of 33.4 mm and is installed instead of the bottom bracket. A bicycle frame with BSA bearings (e.g. Shimano Hollowtech) has the appropriate diameter for the motor, with BB92 and BB30 bearings an individual adapter is required. Some of them we have here…
By choosing the motor the following items are included:
- fixing parts
- all the necessary cables and connectors
- speed sensor
- also with extra connector for Gearsensor and 6V light cable with approx. 500 mA. The DPC18 display (not included) has its own light switch, which supplies power to the connector and turns a connected light on. The controller has an additional connection for the Gearsensor, so that both brake connections on the handlebar can be used. If these plugs are not used, they should be sealed, that no water can cause electronic damage. The Gearsensor isn't included.
With this configurator you will find all the necessary and optional components. You can choose between different throttles, displays and chainrings.
You need a special tool for the axle, the second ring can be tighten with the bottom bracket bearing tool for Shimano, SRAM, … For the rest Allen tools are required.
We recommend the use of the Gearsensor to have smooth gear changes.
This motor can be used with 36V 10S batteries. You can set also a low voltage cutoff in the programming.
Rodriguez
Choose Display





